8 Channels Output AC90-250V Input DMX Signal Splitter RE2508H
Model No.: RE2508H Product Manual Download: RE2508H .pdf
RE2508H digital signal distributor is used to DMX512 digital
lighting control signal for amplification and 8 channels
distribution output, each input/output interface adopts high
voltage isolation technology, applied to DMX512 signal via remote
transmission attenuation after the plastic amplification
processing, as well as various distribution output interface,
between input interface and the distribution between output
interface to complete electrical isolation use occasion.
As a result of each interface between independent isolation, and it
can be avoided by controlling circuit, scanner, silicon box
problems and burned precision digital light console, to ensure the
safe operation of digital light console, at the same time also
guarantee DMX signal can normal transfer to all kinds of lighting
equipment, so as to improve the whole digital lighting control
1), DMX signal amplification and 8 channels distribution output.
2), Each input/output interface adopts high voltage isolation
3), Matching all kinds of lighting equipment.
4), Signal types: DMX512, and the RS-485 interface of various digital
5), DMX signal input: RJ45 or 3 PIN pressure buckle terminals.
6), DMX signal output: RJ45 or 3 PIN pressure buckle terminals.
7), Input to output, output to output electrical isolation pressure:
Input Voltage: AC90-250V
Channel: 1CH In & 8CH Out
Input Signal: DMX512
Output Signal: DMX512
Segregation Voltage: > 1000 V
Power Consumption: <1.5W
Protection Grade: IP40
Input/Output Socket: RJ45/Pressure Terminal
Gross Weight: 935g
Product Size: L256*W138*H35mm
Tech-Parameters of DMX Signal Splitter Series:
1CH in/2CH out
1CH in/1CH out
1CH in/1CH out
DMX Address Dispenser by Digital Tube
1CH in/4CH out
1CH in/8CH out
8CH in/8CH out
(Up side): The power input throutgh 3 PIN terminals. Eight groups
3PIN terminals for DMX signal output. See the panel to correct
(Down side): Eight RJ45 network interfaces for DMX signal output,
the DMX signal termination switch.
DMX512 Control Signal Connection:
1. DMX signal cable is made of twisted pair (line), DMX signal
includes positive and negative end, in pressure welding DMX signal
line plug should pay special attention to polarity.DMX512
controller output signal positive, signal negative, signal ground
with DE8008 input interface corresponding connection.
2. DMX5000 output and DE8008's transmission lines can't be over 300
3. DMX5000 each interface can with not more than 170 DE8008. Eight
output interface. Through the JBLED FLASH light making software and
can with computer on line control. Realize infinite contact the DMX
4. When contacting 32 DE8008, DMX signal must add a signal amplifier
RE2508H. Cascade can't more than 4 PCS.